Search results for "Extrusion moulding"
showing 4 items of 4 documents
Correlation between processability and properties of a high density polyethylene by a rheological approach
2002
The thermal-oxidative and thermal-mechanical stability of high density polyethylene (chromium based catalyst technology) was examined at many different temperatures using a rheological approach. The changes in molecular structure, which take place during processing, have been studied using a Clextral co-rotating twin-screw extruder in comparison with dynamic measurements performed with a rotational rheometer under definite conditions of temperature, strain and frequency and in presence of air. In order to evaluate the degradation response, an investigation of elastic modulus G' as a function of frequency ω on the residual sample after ageing has been carried out. The molecular weight increa…
Recycling of compatibilized and uncompatibilized nylon/polypropylene blends
2001
The recycling of compatibilized and uncompatibilized nylon6/polypropylene blends has been carried out by repetitive extrusions. The change of the properties of the blends is a function not only of the number of reprocessing steps but also of the type of compatibilizer. The worsening of the mechanical properties is small and, indeed, some improvement can be observed after one or two extrusion steps for some blends. It is hypothesised that the decrease of the molecular weight, the typical effect occurring during this thermomechanical treatment, is counterbalanced and overcome by the possible formation of new copolymers that act as bridges between the two phases. This behaviour is displayed by…
Recycling of a starch-based biodegradable polymer
2002
A new starch-based polymeric system, ZI1OU from Novamont, mainly composed of starch and polycaprolactone, was reprocessed several times in an extruder to investigate the recyclability of this biodegradable polymer. A previous investigation of the thermomechanical degradation in a mixer has been also done. The degradation is mostly due to the thermal stress but the presence of the mechanical stress strongly increases the degradation kinetic. During melt processing two concurrent processes take place: the first is the degradation, i.e. the breaking and shortening of polymeric chains, mostly occurring in the PCL phase; the second is the formation of some crosslinked structure in the starch pha…
Processing and mechanical properties of organic filer-polypropylene composites
2005
The addition of organic fillers into thermoplastic polymers is an interesting issue, which has had growing consideration and experimentation during the last years. It can give rise to several advantages. First, the cost of these fillers is usually very low. Also, the organic fillers are biodegradable (thus contributing to an improved environmental impact), and finally, some mechanical and thermomechanical properties can be enhanced. In this study, the effect of the addition of different organic fillers on the mechanical properties and processability of an extrusion-grade polypropylene were investigated. The organic fillers came from natural sources (wood, kenaf, and sago) and were compared …